Sale! test kits/MDMA/ home drugtest kit

The ecstasy testing kits contain a combination of chemicals called a 'Marquis Reagant'. A '"reagent" in this case means a chemical or combination of chemicals which, because of the reaction they cause, can be used in the testing or analyses of other chemicals. The primary use of the marquis reagent in the United States is by law enforcement as a field test for the presence of amphetamine and opiates. It's only within the past three years that they have started to be marketed to the public as a harm reduction tool.

Standard urine tests conducted by a facility may be tested for temperature as well as the presence of drugs. The temperature check is to confirm that the sample was provided by the individual being tested and not switched with someone else's urine in an effort to beat the test.

The urine sample given by the individual being tested is used to detect toxins that remain in the body after illegal drugs are used. The toxins are stored in the fat cells. When the fat is burned in the body, the toxins are released into the bloodstream. Once the toxins reach the bloodstream, they are filtered through the kidneys. Eventually, they are excreted from the body in urine.

Urine samples exhibiting visible precipitates should be filtered, centrifuged or allowed to settle. Use only clear aliquots for testing.

1. Review Specimen collection instructions. Test device, patients samples, and controls should be brought to room temperature (20-30) prior to testing. Do not open pouches until ready to perform the assay.
2. Remove the test strip from its protective pouch (bring the device to room temperature before opening the pouch to avoid condensation of moisture on the membrane). Label the device with patient or control number.
3. Fill a test tube or urine cup with sample.Holding the strip vertically,place it into the sample container.the urine level should not be higher than the mix level indicator line on the strip.Do not cover the urine over the max (maximum) line. You may leave the strip in the urine or you may take the strip out after a minimum of 15 seconds in the urine and lay the strip flatly on a non-absorptive clean surface.)and then start the timer. Use a separate pipette and device for each sample or control.
4. Read result between 3 to 8 minutes after the addition of samples. Do not read result after 8 minutes.