High performance tension KTC-820 signal amplifier,can replace Mitsubishi LM-10PD Connect with PLC
Tension Signal Amplifier KTC820 can be used by mating with the LX series tension transducer. It can amplifier the weak tension signal to 0~10V or 4~20m A current output. It is input valtage is AC220 V
1. just need two steps during the process of calibration, easy operation
2. full-digital process, no potentiometer adjustment, stable and reliable, no drift
3. real-time display of the measured tension value
4. support the 0~10V analog quantity output
5. support the 4~20m A current output
6. support the Modbus RTU Digital Communication, easy and convenient connection with PLC, guarantee no damage of signal transmission
7. settable tension alarm output ( relay is always on/normally-closed contact output
8. adjustable output ratio
9. standard navigational installation
technique parameter
NO | Name | Introduction | Value |
1 | Zero | Zero tension setting | 0 |
2 | Full | Full range seeting | 0-999.9 |
3 | CHL | Sensing channel selection | Can choose left/right/ Left and right |
4 | 210 | The sensing signal level | Can set 30mv or 300mv |
5 | Out 0 | Zero tension output valtage | Can set 0.00v to 10.00v |
6 | Out F | Full range output valtage | Can set 0.00v to 10.00v |
7 | 10 | Zero tension output current | Can set 0.00mv to 20.00mv |
8 | 1F | Full range tension output current | Can set 0.00mv to 20.00mv |
9 | FILT | Filtering time | Can set 0.1s to 10.0s |
10 | b Rud | Baud rate | Can set 4.8k(4800bps).9.6k(9600bps),19.2k(192000bps) |
11 | R ddr | communication address | Can set 1-99 |
12 | RLr | Tension alarm | Can set 0-999.9 |
Usage: it can use in any brand tension loadcell , tension transducer , can replacMitsubishi LM-10TA it is widely use in the tension control in the printing machine , laminations machine , slitting machine etc
