Factory Direct Industrial Self Priming Water Pump

industrial water pumpwater pumpSelf Priming Water Pump

Product features

1. The pump is of vertical structure. The inlet and outlet diameters are the same, and they are on the same center line. It can be installed in the pipeline like a valve. Its appearance is compact and beautiful, its floor area is small, and its construction investment is low. If a protective cover is added, it can be used outdoors.

2. The impeller is directly installed on the lengthened shaft of the motor, with short axial dimension and compact structure. The pump and motor bearings are reasonably configured, which can effectively balance the radial and axial loads generated by the pump operation, thus ensuring that the running balance vibration noise of the pump is very low.

3, shaft seal adopts mechanical seal or mechanical seal combination, wear-resistant seal, can effectively increase the service life of mechanical seal.

4. The installation and maintenance are convenient. The pipeline system does not need to be removed. All rotor components can be extracted by removing the nut of the pump coupling seat.

5. The series and parallel operation of pumps can be adopted according to the use requirements, i.e. the flow rate and lift.

6. Vertical and horizontal installation of pumps can be adopted according to the requirements of pipeline layout.

use Suitable for long-term transportation of acid, alkali liquor, oxidant and other corrosive liquids of any concentration. Guangfa is used in petroleum, chemical industry, metallurgy, electric power, papermaking, flue gas desulfurization, dust removal, food and pharmacy, synthetic fiber and other departments.

Conditions of use:

1. The suction pressure is ≤1.0Mpa, or the high working pressure of the pump system is ≤1.6Mpa, i.e. the pump suction pressure+pump head ≤ 1.6Mpa, and the static pressure test pressure of the pump is 2.5Mpa. Please indicate the working pressure of the system when ordering. When the working pressure of the pump system is greater than 1.6Mpa, it shall be proposed separately at the time of ordering. So as to adopt cast steel materials for the over-current components and the connecting parts of the pump during manufacturing.

2. ambient temperature < 40°C, relative humidity < 95%.

3. the volume content of solid particles in the transported medium shall not exceed 0.1% of the unit volume and the particle size shall be less than 0.2 mm.

Note: If the medium used is with fine particles, please explain it when ordering so as to adopt wear-resistant mechanical seal.

Partial performance parameter table

structural representation